Goodco Z-Tech to Supply Structural Bearings and Expansion Joints for Rehabilitation Work to the Champlain and Jacques Cartier Bridges

Share

February 27, 2012

Goodco Z-Tech recently obtained a contract for the fabrication of expansion joints in the scope of the rehabilitation of the Champlain Bridge located in Montreal, Quebec.

Jacques_Cartier_bridges
Photo: JCCBI Approximately 59.4 million vehicles cross the Champlain Bridge each year.
Jacques_Cartier_Bridge2
Photo: Wikipedia Some 35.8 million vehicles travel the Jacques Cartier Bridge annually.

The contract, which was granted by The Jacques Cartier and Champlain Bridges Incorporated (JCCBI), is for the fabrication of four Goodflex bolt-down joints measuring 80 ft. (24.3 m) each. The expansion joints will be fabricated between March and April and be delivered to the site in May.

Replacement of Structural Bearings on the Jacques Cartier Bridge

Goodco Z-Tech equally concluded an agreement last fall with St.Lawrence Erectors for the design and fabrication of 12 elastomeric unidirectional pot bearings (PMG) to replace the structural bearings in sections 2, 4, 7 and 8 of the Jacques Cartier Bridge, also located in Montreal. Fabrication of these components began in January and will continue through April, while deliveries are slated to take place from February to mid-May. The replacement work, which is being executed underneath the bridge structure, will entail complete bridge closures during night hours in order to avoid the additional weight caused by circulating traffic.

To top